Need help with ethernet switch

  • Thread starter Thread starter Mint
  • Start date Start date
In message <[email protected]> Loren
Pechtel said:
In the old days before they could autosense whether a connection was
crossed or not they generally did have a line in.
Click to expand...

Well, it was generally called an "Uplink", but from the switch's point
of view there was nothing special about the port (it was just wired
differently)

There's no "in" or "out" there are just ports.
 
DevilsPGD said:
In message <[email protected]>


Yes. Or you can use a cross cable to cross-connect two switches without
using uplink ports.
Click to expand...


Thanks a lot. I was figuring that the uplink was something else, different
from a LAN port.
Wonderful, I've two cascaded switches, both full, this is bringing two ports
more !
 
Mark Lloyd said:
frischmoutt wrote:

[snip]
Thanks a lot. I was figuring that the uplink was something else, different
from a LAN port.
Wonderful, I've two cascaded switches, both full, this is bringing two
ports more !
Click to expand...

You don't always get an additional port. On many switches with an uplink
port. 2 ports are connected to the same wires (just different port pins). If
that's the case, you can't use both ports.

--
26 days until The winter celebration (Saturday December 25, 2010
12:00:00 AM).

Mark Lloyd
http://notstupid.us

"The surest way to corrupt a youth is to instruct him to hold in higher
esteem those who think alike than those who think differently." --
Friedrich Nietzsche
Click to expand...

I just had a thourough look, the switches are Zonet ZFS3005.
On the rear, the uplink is close to the port 1.
Below these twioports, a printed white line joins both the port labels ...
That's not mentioned in the user's sheet.
Two bad, too bad :-(
regards
 
Does this meas that a port can be gained provided that a cross cable is used
to connect another computer ?

Regards
Click to expand...

It's counted as one of the ports. That's why 5-port hubs were
common--1 in, 4 out.
 
Back
Top