A7N8X-E Dlx, 3200+, Kingston Valueram, setup problem.....

  • Thread starter Thread starter Ron Todd
  • Start date Start date
Hi, I finally got mine to run 200mhz FSB. Tried the same Kingston;
KVR400X64C3AK2/1G that you have. Kingston engineers said it should work ok--
Runs at 200, but is visibly slower than the old Kingston I had, even running
in dual channel. Decided to try Cosair (on ASUS QVL) CMX512-3200C from
MWAVE, their part number BA08584, so far its running GREAT at 200mhz, dual
channel, set 8,3,3,2.5. Athlon XP3200 A OK at 2200mhz. Will run memtest86
and benchmark next week-I'll post results. Good Luck! Paul
 
I am beginning to get the feeling that I am going to have to spring
for the Corsair or something equivalent also.
 
Hi, I finally got mine to run 200mhz FSB. Tried the same Kingston;
KVR400X64C3AK2/1G that you have. Kingston engineers said it should work ok--
Runs at 200, but is visibly slower than the old Kingston I had, even running
in dual channel. Decided to try Cosair (on ASUS QVL) CMX512-3200C from
MWAVE, their part number BA08584, so far its running GREAT at 200mhz, dual
channel, set 8,3,3,2.5. Athlon XP3200 A OK at 2200mhz. Will run memtest86
and benchmark next week-I'll post results. Good Luck! Paul
Click to expand...

Bit the bullet and bought the Corsair 3200LL set. It has been running
rather nicely for the last six hours at 197/197. I had it at 200 for
about an hour and then got a hang. I got a strange message back from
MS crash analysis about the ATI driver being a problem and upgraded
that from the ati site. Tomorrow I might step it back up to 200 and
see if it will hold. I conclude that this board did not like the
Kingston memory and I have an "issue" with Mwave.com.

Tnx for the help.
 
Back
Top