B
Blesavi Danac
Hi.
I have an immensely annoying problem with my XP Home setup. I recently
bought a new WD 320gb IDE disk, and i want to partion it into two 50gb
partitions and one 220gb partition - then install a new XP on one of the 50gb
partitions. However, during setup, i am told that the harddrive is only
130gb. I tried completing the install to check in Disk Management, but it's
the same there. In various articles i found out that i might need a driver
from a floppy during installation, but don't have a floppy drive.
Is there another way around this problem?
I have an immensely annoying problem with my XP Home setup. I recently
bought a new WD 320gb IDE disk, and i want to partion it into two 50gb
partitions and one 220gb partition - then install a new XP on one of the 50gb
partitions. However, during setup, i am told that the harddrive is only
130gb. I tried completing the install to check in Disk Management, but it's
the same there. In various articles i found out that i might need a driver
from a floppy during installation, but don't have a floppy drive.
Is there another way around this problem?