X800 GTO AGP + analog LCD monitor

  • Thread starter Thread starter jack
  • Start date Start date
J

jack

I bought a new X800 GTO (AGP version) - replacing a 9500 PRO - to use
with my analog LCD monitor (AOC LM-800). However, when I boot up I
fail to get a picture on screen until windows starts to load. Before
then I just get the message "input not supported".

Fortunately I can still bring up and see the BIOS screen if I press
the relevant key, but what I don't get to see is the usual boot-up
info prior to windows.

This isn't a major concern, but I was just wondering if anyone else
has experienced this?

jack
 
You may want to update your drivers. That should do it, but it doesn't
really matter if everything else works.

John
 
I bought a new X800 GTO (AGP version) - replacing a 9500 PRO - to use
with my analog LCD monitor (AOC LM-800). However, when I boot up I
fail to get a picture on screen until windows starts to load. Before
then I just get the message "input not supported".

Fortunately I can still bring up and see the BIOS screen if I press
the relevant key, but what I don't get to see is the usual boot-up
info prior to windows.

This isn't a major concern, but I was just wondering if anyone else
has experienced this?

jack
Click to expand...


Do you have Primary Display (it goes under a lot of names - might be
Init Display First) set to AGP rather than PCI in BIOS?

Patrick

<[email protected]> - take five to email me...
 
John said:
You may want to update your drivers. That should do it, but it
doesn't really matter if everything else works.
Click to expand...

The driver doesn't load 'till Windows boots, so updating the drivers will
not help.

Martin
 
Back
Top