With HPNA network set up and showing as connected, DSL connection is lost

  • Thread starter Thread starter steve
  • Start date Start date
S

steve

This is a repeat (updated) of an older post regarding a problem which
is still unsolved.

\I recently acquired a DSL connection (ATT/Yahoo). It was connected
to
my wife's computer (a Dell laptop running Windows XP). In order to
be
able to access the DSL on my own computer (a HP desktop also running
Windows XP) I obtained a couple of 2Wire home phone network adapters,
hooked them up, installed the drivers and ran Windows Network Wizard
on both computers.

There are two problems:


1) With both 2Wire connections enabled DSL cannot be accessed on my
wife's (host) computer (and obviously not on my computer either).
However, if you disable the 2Wire connection on the host computer,
DSL
is restored but home network functionality is lost.


2) When the home network connections are enabled and shown as
"connected" and you
open "see workgroup computers" then the computer you're on is
displayed but not the other computer, plus when you open "network
places" you see shared folder for both computers but when you try to
open the shared folder of the other computer you get an error message
(something like access denied maybe you don't have permission?)
 
You only need one ADSL modem/Router. Both computers should be
connected to it, using an ethernet switch if necessary.
 
There is only one ADSL modem and it is connected to the "host"
computer and the "host" computer runs DSL great so long as there is no
home network connection.

According to my information, only one computer can be connected to a
DSL modem. If you want to share the DSL modem with other computers,
you have to have a home network. This can be ethernet, wireless or
HPNA. I have the HPNA. However, when I hook up the HPNA network and
configure it to the best of my ability, I get the problems described
in my intital post.
 
Back
Top