I
ICU
Hi, I need help/advice on the MFT settings for a hard disk partioned into
"C" and "D" drives.
When using Diskeeper to analyze or Defrag both drives I get a warning that
"D" is using 97% of MFT and that I should increase the MFT setting.
I realize that Diskeeper has an option which can change the MFT, but I
prefer not to use third party software to make this kind of change, just
paranoid I guess.(G)
There is no seting currently showing in the registry for the MFT as far as
I can see so I guess the the defalt of 1 is being used.
If the command, "fsutil behavior set mftzone 2" is used will that change
the MFT on both drives "C" and "D: or should this command be used to just
change the MFT setting on "D" drive and if so what is the correct command
line to do that.
TIA
"C" and "D" drives.
When using Diskeeper to analyze or Defrag both drives I get a warning that
"D" is using 97% of MFT and that I should increase the MFT setting.
I realize that Diskeeper has an option which can change the MFT, but I
prefer not to use third party software to make this kind of change, just
paranoid I guess.(G)
There is no seting currently showing in the registry for the MFT as far as
I can see so I guess the the defalt of 1 is being used.
If the command, "fsutil behavior set mftzone 2" is used will that change
the MFT on both drives "C" and "D: or should this command be used to just
change the MFT setting on "D" drive and if so what is the correct command
line to do that.
TIA