WinXp : How to select a particular network connection for transfering files ?

  • Thread starter Thread starter Yves Sacré
  • Start date Start date
Y

Yves Sacré

I have several PC's, hooked up to a 100 MBits standard router/internet
gateway by means of RJ-45 cables. (IP adresses in the range
192.168.0.xxx).

On the other hand, I wanted to transfer large files between two PC at
higher speed than what 100 MBits Ethernet would allow. I tried to
connect two PC's with a firewire cable. It worked really good. Windows
XP took care of the settings (I think he assigned IP adresses in the
range 10.0.0.xxx), and transfer speed was much higher.

The only drawback is when the two cables (Ethernet and Firewire) are
plugged together in the computer : I can't 'choose' which interface
the data should take, and files are transferred through the ethernet
network at the slower speed, instead of flowing directly to the other
computer through the firewire connection...

The only solution I have until now is to manually disable the RJ-45
interface (either through the network properties of Windows or by
removing the cable), but I soon need to switch it on again to access
the Internet.

How could I do to tell Windows which network I want to use to transfer
files ?

Any help welcome.

Thanks.
 
Yves said:
The only solution I have until now is to manually disable the RJ-45
interface (either through the network properties of Windows or by
removing the cable), but I soon need to switch it on again to access
the Internet.

How could I do to tell Windows which network I want to use to transfer
files ?
Click to expand...

What if you simply disable the File and Print sharing on the Ethernet
connection?

--
Ben Cottrell AKA Bench

Disclaimer:
This post may contain explicit depictions of things which are "real".
These "real" things are commonly known as 'life'! So, if it sounds
sarcastic, don't take it seriously. If it sounds hazardous, Do not try
this at home or at all. And if it offends you, just don't read it.
 
I assume you use regular Windows file sharing (i.e. no IP/TCP based protocol
such as FTP)

See
http://www.microsoft.com/windows200...chinfo/reskit/en-us/intwork/inde_nbf_SPKS.asp

Basically, windows file sharing uses the NetBEUI protocol which is not IP
based and not routable.

I have not tried myself, but perhaps you can change the priorities of the
adapters (see
(http://www.microsoft.com/windows2000/techinfo/reskit/en-us/intwork/inde_nbf_xpxw.asp)
to get what you want

Alternatively, use an IP-based file sharing protocol (e.g. FTP or NFS) and
regular IP routing settings to get the desired behavior
 
Back
Top