WinXP don't boot from RAID 0

  • Thread starter Thread starter Rzaba
  • Start date Start date
R

Rzaba

I have Abit NF7S v 2.0 and 2 maxtor Sata harddrivers.
WinXP normaly boot if one HD is connected but if 2 hard
drivers are connected in RAID 0 array WinXP don't boot. I
can see only blank screen.
 
Is this a new setup?
Raid drivers installed?
If so have you built the array correctly, raid config. usually available
during post process.
You havnt set one as a slave?
If prev ok do you not get any raid error msg during start up?
A few thoughts,
David
 
I have an MSI-6728 with Intel Raid and boot from it. Configuring the setup took some trial+error with the BIOS but is smooth now! Post your BIOS settings for you disk interfaces and check Abit's site, do they have discussion groups? MSI groups helped me a lot!

Derek
 
Back
Top