Windows crash issues

  • Thread starter Thread starter Marc
  • Start date Start date
M

Marc

I can use a little help here. I have a newer AMD athalon
64 3000+ on a K8T-NEO mobo, running a 120gSATAHD with a
OEM version of Windows XP Pro. My problem is that I can't
get windows to start up. It will start, show the windows
screen for approx. 14sec., then show a flash of a blue
screen of death error, then restart. I tried to restart
in safe mode, but when it tries, it lists all the current
drivers, freezes for a moment, then restarts again. I
believe I have traced my problem down to "How to recover
from a corrupted registry that prevents Windows XP from
starting", located on windows help page somewhere,but this
thread only applies to NON-OEM versions of Windows. If
anyone can tell me if I might be on the right track here
for starters, would be greatly appreciated, furthermore,
if anyone knows a FIX for this issue that I might be
having, it would be even better. Thank you all in advance.
..
 
You are on the right track, start with the "How to recovery from a corrupted
registry..." If that fails to resolve it, try a repair install as follows:
NOTE, while a repair install should leave your data files intact, if
something goes wrong during the repair install, you may be forced to start
over and do a clean install of XP. If you don't have your data backed up,
you would lose your data should that eventuality occur.

Assuming your system is set to boot from the CD-ROM drive and you have an
actual XP CD as opposed to a recovery CD, boot with the XP
CD in the drive and perform a repair install as outlined below. If the
system isn't set to boot from the CD or you are not sure, you need to enter
the system's BIOS. When you boot the system, the first screen usually has
instructions that if you wish to enter set press a specific key, when you
see that, do so. Then you will have to navigate to the boot sequence, if
the CD-ROM drive is not first line, set it first in the boot sequence. Save
your settings and exit with the XP CD in the drive. The system will reboot.

When the system boots, a few screens into the process you may see a message
instructing you
to hit any key in order to boot from the CD along with a countdown. When
you see this be sure to
hit a key on the keyboard, if you miss this instruction and the system fails
to boot from the CD, it's too
late, you'll need to reboot and try again.

Once you have pressed a key, setup should begin. You will see a reference
asking if you need to load special drivers and another notice that if you
wish to begin the ASR (Automatic Recovery Console) depress F2. Just let
setup run past all of that. It will continue to load files and drivers.

Then it will bring you to a screen. Eventually, you will come to a screen
with the option to (1) setup Windows or (2) Repair Windows Installation
using the Recovery console. ***The selection you want at this screen is
"Setup Windows,"
NOT "Repair Windows Installation.

The first option, to setup Windows is the one you want and requires you to
press enter. When asked, press F8 to accept the end user agreement. Setup
will then search for previous versions of Windows. Upon finding your
version, it will ask if you wish to Repair your current installation or
install fresh. Press R, that will run a repair installation. From there
on, follow the screens.

If you only have a recovery CD, your options are quite limited. You can
either purchase a retail version of XP will allow you to perform the above
among other tools and options it has or you can run your system recovery
routine with the Recovery CD which will likely wipe your drive, deleting all
files but will restore your setup to factory fresh condition.

In the future, if your post is more than a few lines, please try breaking it
into more than one paragraph; makes it easier to read.

Thanks.
 
Back
Top