Will not automatically connect to wireless network

  • Thread starter Thread starter tdp
  • Start date Start date
T

tdp

I am running Vista x64 on a wireless network, WPA, TKIP. The network connects
and works fine when you connect manually, but even if you check the
"automatically connect" checkbox, after turning off the computer you have to
connect manually again and the checkbox is unchecked.

Had an XP machine with wireless before and this was never a problem. Have a
Vista x32 connected with Ethernet cable that has no problem getting on
network automatically either.

Router is WRT54GS (I know it's old), but my computer is not totally
incompatible if I get a good connection and good speed on the network. Seems
that I am not the only one having this problem on this forum, but the other
cases seemed somewhat different?

Thanks in advance for any help.

tdp
 
Hi
If the computer has also Wire Network Card configure the Metrics to prefer
the Wireless.
This page was written for WinXP, the principle is the same for Vista the
menus to get there are different but easy to adjust to Vista.
http://www.ezlan.net/metrics.html
Jack (MS, MVP-Networking)
 
I found out that the problem is with Lenovo's own network software that comes
pre-installed on the computer (I don't remember what it's called because I
uninstalled it :)!! ) If you uninstall that proprietary software and
reconfigure your network through Control Panel>Network and Sharing Center,
the checkbox to automatically connect will stay checked and everything will
work fine; at least, that's what happened with me.
 
I had the EXACT same problem. It wasn't a big deal, just a hassle to have to
manually reconnect EVERY time I booted up my Lenovo Y550 or it came back from
sleeping or hibernating. I disabled ReadyComm and it works perfectly now! So
much for two hours on the phone with Lenovo tech support. Thank you so much
 
Back
Top