Which CAB file for Xscale processors?

  • Thread starter Thread starter Dave M
  • Start date Start date
D

Dave M

I'm targeting PDAs with Xscale processsors. When installing the application
on the device using a CAB, do I want to use the *.ARM.CAB or *.ARMV4.CAB?
Can anyone tell me when I'd use one over the other?

Thank you
 
Do you know if it is possible to run ARM Cab's on PPC 2003?

Regards
Lorents Hildrum
 
Lorents,

Yes, WM2003 is backwards compatible.

As a matter of interest, just after I upgraded my iPAQ 3970 from PPC 2002 to
WM2003, I continued to use my ARM cabs on it without a problem. Later, I
began using the ARMV4 cabs, again without problem. Hope this helps.

Regards,
Neville Lang
 
Back
Top