"vtl dr is missing"

  • Thread starter Thread starter A Hegarty
  • Start date Start date
Did you meant 'ntldr' ? Is there a primary active partition? Are you
installing? To do a clean install, usually best to either boot the Windows
2000 install CD-Rom or setup disks. The set of four install disks can be
created from your Windows 2000 CD-Rom; change to the \bootdisk directory on
the CD-Rom and execute makeboot.exe (from dos) or makebt32.exe (from 32 bit)
and follow the prompts.

When you get to the point, delete the existing NTFS and or other partitions
found. After you delete the partition(s) abort the install, then again
restart the pc booting the CD-Rom or setup disks to avoid unexpected drive
letter assignments with your new install.

Alternately try booting the recovery console and from a command prompt issue
the command;
fixboot

To start the Recovery Console, start the computer from the Windows 2000
Setup CD or the Windows 2000 Setup floppy disks. If you do not have Setup
floppy disks and your computer cannot start from the Windows 2000 Setup CD,
use another Windows 2000-based computer to create the Setup floppy disks.
Press ENTER at the "Setup Notification" screen. Press R to repair a Windows
2000 installation, and then press C to use the Recovery Console. The
Recovery Console then prompts you for the administrator password. If you do
not have the correct password, Recovery Console does not allow access to the
computer. If an incorrect password is entered three times, the Recovery
Console quits and restarts the computer. Once the password has been
validated, you have full access to the Recovery Console, but limited access
to the hard disk. You can only access the following folders on your
computer: %systemroot% and %windir%

Or try creating a boot disk. For the floppy to successfully boot Windows
2000 the disk must contain the "NT" boot sector. Format a diskette (on an NT
machine, not a DOS/Win9x, so the NT boot sector gets written to the floppy),
and copy ntldr, ntdetect.com, and boot.ini to it; and possibly ntbootdd.sys.
Edit the boot.ini to give it a correct ARC path for the machine you wish to
boot.


--
Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft MVP [Windows NT/2000 Operating Systems]
Microsoft Certified Professional [Windows 2000]
http://www.microsoft.com/protect


:
| I am getting this meesage when I boot my machine.
| Any thoughts?
 
-----Original Message-----
I am getting this meesage when I boot my machine.
Any thoughts?
.Hi - same issue, see my posting just below.
Click to expand...
The knowledge base advises install a ''Bcupdate2 utility''
Which I can't find. Any result, let me know.
Raymond
 
Back
Top