VPN & RAS on the same server

  • Thread starter Thread starter Giannis Wired
  • Start date Start date
G

Giannis Wired

I setup a RAS server
This server works fine as ras server .

I want now to do this server a VPN host server to accept
incoming connection but from add new connection incoming
new connection i have a warning message that says go to
remote and routing cosnole but in this console the
configure routing and remote server is not enable only the
option disable configure routing and remote server id
enable

Is posible to have and ras and vpn on the same server how
i can go to the add new incoming connection procedure
without routing and remote access console

thank you
 
How did you set it up to accept a RAS connection? Did you use the RRAS
console, or did you just set up an incoming connection?

VPN is just a special case of RAS which uses tunnelling through the
Internet instead of modems. When you configure the remote access server you
just accept the "allow VPN connection" option to set up the WAN miniports.
Everything else works the same way - accounts, permissions, policies etc.
 
I used RRAS console but now i cant m add new connection }
accept incoming calls

Where excalty is the option allow vpn connection

Thank you
 
The easiest way is to disable RRAS, then reconfigure it. Select the
remote access option in the wizard, and select the option to allow VPN
connections. This will set up the WAN miniports for VPN as well as allowing
connections by modem.
 
Back
Top