Vista x64 sp1 hangs on stage 3 after 76%

  • Thread starter Thread starter Dani
  • Start date Start date
D

Dani

I'm trying to install the sp1 on vista x64.
The machine is hp xw4400

Installation runs until stage 3 and hangs on 76%.
Restarting the computer just make it happen again (Stage 3, 76% and hangs...)

Any ideas ?

Dani
 
What product are you using (retail, OEM, full, upgrade etc.) and what kind
of install are you doing. Stage 3 is where the drivers for the video card
drivers have caused many problems. Also other items like USB devices cause
problems. You don't say how long you wait, are you sure you are not
impatient? Some types of installs can take quite a long time. Remember to
collect the 64-bit drivers for each item requiring drivers that aren't in
Vista, like the MOBO etc. If you are doing a clean install, try adding the
driver for the video on the page where you select the location to install.
 
I think you are right...
I've restarted the computer in Safe Mode - and the installation continued
pass the 76% mark (probably b/c the bad "Driver" was disabled). yet.. at the
end I got a message that the service pack did not install correctly and the
computer went back to the previous position.

I'm not sure which driver caused the hang of the installation, but it looks
like no sp1 for me....

Dani
 
In another thread I complain about the exact same phenomenon and Mr. Barnes
asks "What's your problem?" and "You didn't let it finish." Baloney.
 
Back
Top