Vista don't get IP Automatically after a bad shutdown in WLAN

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I had normally my WLAN profile configured fine, but after a bad shutdown. My
computer, now never get a valid IP, only if I configure a valid IP the
connection works. I have been checking my router but it's ok.

Where is the problem?
 
Many possible causes. I would check the NIC driver and router firmware first. Or this link may help,

Vista Wireless IssuesVista: Common Problems with 802.11 Wireless ... Inability to Connect and the wireless doesn’t receive the single. 1) It could be the Wireless adapter driver ...
http://www.wifimvp.com/vistawireless.htm


Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com
I had normally my WLAN profile configured fine, but after a bad shutdown. My
computer, now never get a valid IP, only if I configure a valid IP the
connection works. I have been checking my router but it's ok.

Where is the problem?
 
Thanks for you reply, but isn't work.
I have been testing to re-install the wlan driver and doesn't works. And
about the firmware of router is totally independent of the O.S. so, I think
that is something of this O.S.
btw the link that you post doens't work.

Rgds.
 
The link should work. Also the Microsoft has a update for fixing the Vista wireless issues.

Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com
Many possible causes. I would check the NIC driver and router firmware first. Or this link may help,

Vista Wireless Issues Vista: Common Problems with 802.11 Wireless ... Inability to Connect and the wireless doesn’t receive the single. 1) It could be the Wireless adapter driver ...
http://www.wifimvp.com/vistawireless.htm


Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com
I had normally my WLAN profile configured fine, but after a bad shutdown. My
computer, now never get a valid IP, only if I configure a valid IP the
connection works. I have been checking my router but it's ok.

Where is the problem?
 
try reinstall TCP/IP

Santiago Merino said:
Thanks for you reply, but isn't work.
I have been testing to re-install the wlan driver and doesn't works. And
about the firmware of router is totally independent of the O.S. so, I
think
that is something of this O.S.
btw the link that you post doens't work.

Rgds.
Click to expand...
 
How can reinstal TCP/IP? I must uninstall the "Client for Microsoft Networks"
and install again?
 
I have discover that if I disable IPv6 then get a valid IP. And also I have
been trying make a connection by ethernet with the same results. But in this
case if I disabled the IPv6, the ethernet interface get IP but don't works
dns resolutions.

Any suggestion?
 
Back
Top