usage Sandisk tool

  • Thread starter Thread starter Micha
  • Start date Start date
M

Micha

Hi
I get the tool from Sandisk but is doesn´t work.

usage:
atcfwchg.com /F

but i get only "Fail(#20)"
 
I get the tool from Sandisk but is doesn´t work.

In addition, you may have an older CF, which uses the utility NDCFWCHG. I
recently bought six CF's and one of them did not work with ATCFWCHG, but
*did* work with NDCFWCHG.

Good luck,

Tom Salicos
 
Micha said:
Hi
I get the tool from Sandisk but is doesn´t work.

usage:
atcfwchg.com /F

but i get only "Fail(#20)"
Click to expand...

I think the compact flash card may be on the secondary IDE/ATAPI header.
Try one of the following commands, based on the whether the compact
flash is master/slave and primary(channel 0)/secondary(channel 1).

ndcfwchg /P /F if master on channel 0
ndcfwchg /P /F /1 if slave on channel 0
ndcfwchg /S /F if master on channel 1
ndcfwchg /S /F /1 if slave on channel 1

Jim
 
Tom said:
In addition, you may have an older CF, which uses the utility NDCFWCHG. I
recently bought six CF's and one of them did not work with ATCFWCHG, but
*did* work with NDCFWCHG.

Good luck,

Tom Salicos
Click to expand...

Oops, didn't notice Micha was using the new utility.

Jim
 
This is the response I got from Tuan Dinh Hoang at San
Disk. It worked for me and displayed a large PASSED on
the screen.

Please:
1. Mount the CF as a primary master IDE.
2. Boot from a floppy with the tool on the floopy.
3. Make sure the BIOS see the CF.
4. Isuse atcfwchg /p /f

Ryan
 
Back
Top