unable to go VPN router to router.

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Have setup VPN server on W2K Server system. Works great
from cable modem and dial in to ISP. But when going from
remote router to router at server am unable to access
anything on network.

Connection is made but unable to ping server or use
client to get to information on networked disk drives.

Do you have any ideas?
 
post the routing table here by using route print command.

--
For more and other information, go to http://www.ms-mvps.com

Don't send e-mail or reply to me except you need consulting services.
Posting on MS newsgroup will benefit all readers and you may get more help.

Robert Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN, Anti-Virus, Tips & Troubleshooting on
http://www.ms-mvps.com
This posting is provided "AS IS" with no warranties.
 
A router to router VPN does not set up any routing by default. You need
to use static routes linked to the demand-dial interfaces to route between
the sites.

If you have done this and can ping by IP address between sites, the next
step is to organise DNS and/or WINS to allow ping by name between sites.
 
Back
Top