Ultra ata drive

  • Thread starter Thread starter Carlos Albert
  • Start date Start date
C

Carlos Albert

I have a P3 450 Mhz with W2000 SP4 with two hard drive and two CD. I have
installed a Promise Ultra Ata 133 controller without problem. I connect a
Ultra Ata Seagate Hard Drive 120 Gb to this controller, I installed the
drivers to this controller. In the Hardware Administrator of the Control
Panel, Windows recognize the ultra ata controller perfectly under RAID SCSSI
Controllers but the Hard Drive appears with a Warning, Windows saids that
"don't have a driver for the device. Code Error 28". Windows recognize it as
a SCSSI hard drive (I think its normal). In the Disk Administrator the drive
appears with its correct size but it is imposible to format it, windows
says: "the hard drive is not enabled, it enables next Windows restart" I
don´t understand what is happening, the hard drive is correct because I
check it in another computer directly on the Mother Board. The Model of the
Hard Drive is ST120022A. Someone can help me?

Thanks at all.
 
If the new controller is raid, then you'll likely need to build an array in
controller bios in order to use the drive.

--
Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect

:
|I have a P3 450 Mhz with W2000 SP4 with two hard drive and two CD. I have
| installed a Promise Ultra Ata 133 controller without problem. I connect a
| Ultra Ata Seagate Hard Drive 120 Gb to this controller, I installed the
| drivers to this controller. In the Hardware Administrator of the Control
| Panel, Windows recognize the ultra ata controller perfectly under RAID
SCSSI
| Controllers but the Hard Drive appears with a Warning, Windows saids
that
| "don't have a driver for the device. Code Error 28". Windows recognize it
as
| a SCSSI hard drive (I think its normal). In the Disk Administrator the
drive
| appears with its correct size but it is imposible to format it, windows
| says: "the hard drive is not enabled, it enables next Windows restart" I
| don´t understand what is happening, the hard drive is correct because I
| check it in another computer directly on the Mother Board. The Model of
the
| Hard Drive is ST120022A. Someone can help me?
|
| Thanks at all.
|
|
|
|
 
Hello Dave:

No, the controller is not Raid, it has two IDE inteface but it is not RAID.
When the computer starts the bios of the Ultra Ata controller recognize the
hard drive correctly. But windows saids that need driver for the hard drive,
I never had seen it.

Thanks.
 
This page may help you.

http://www.seagate.com/support/kb/disc/howto/ata_install_tshoot.html

--
Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect

:
| Hello Dave:
|
| No, the controller is not Raid, it has two IDE inteface but it is not
RAID.
| When the computer starts the bios of the Ultra Ata controller recognize
the
| hard drive correctly. But windows saids that need driver for the hard
drive,
| I never had seen it.
|
| Thanks.
 
I'm going to try with this page. I will give the result to the group.

Thanks Dave
 
OK, good luck.

--
Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect

:
| I'm going to try with this page. I will give the result to the group.
|
| Thanks Dave
 
Back
Top