UDMA HD working as P10

  • Thread starter Thread starter yitzak
  • Start date Start date
Y

yitzak

Hi

I have 2 identical Maxtor HDisks 5T030h3 - both 30GB. Win 2000 Matsonic
MS8147C motherboard. Both HDs are master and each HD has a DVD/CD
Writer as slave.

I noticed the secondary master was running p10. I checked inside and
found it had an old style 40 pin cable changed it to an 80 one.

In fact I know its all correct cos do NOT get "no 80 cable installed"
message on boot up since I changed cable.

All working fine - but when I look in Windows the secondary disk still
comes up as p10. I checked the BIOS its all auto for all disks. I
looked in the BIOS under Access Mode and the choices were CHS, LBA,
Large, Auto. Was expecting to see UDMA listed?

I'm not confident messing with BIOS - any ideas why this could be
happening?
 
Fixed:

In Device manager - I uninstalled the secondary IDE channel. Reboot and
Windows detects new hardware. Then asks to reboot again. When finished
Drive is now correctly working at UDMA (noticebaly faster)

I found it another post.
 
Back
Top