Tyan board-Opterons-Memory Which?

  • Thread starter Thread starter arnie
  • Start date Start date
A

arnie

From the Tyan site:
Memory
. 128-bit DDR memory bus
. Six 184-pin 2.5-Volt DDR DIMM sockets
- four controlled by CPU1 and two on CPU2
. Supports up to 12GB of Registered DDR
. Supports ECC type memory modules
. Supports PC3200 / 2700 / 2100 / 1600 DDR


When it says it "supports" PC3200 / 2700 / 2100 / 1600
does that mean that all it needs is 1600, and you wont get any real benefit
from the higher speed ram
or does it mean that you will get more performance out of the higher speed
ram.

If I have the Opteron 244 (1.8mhz) which Ram should I have to get the best
performance out of the Processor.
 
From the Tyan site:
Memory
. 128-bit DDR memory bus
. Six 184-pin 2.5-Volt DDR DIMM sockets
- four controlled by CPU1 and two on CPU2
. Supports up to 12GB of Registered DDR
. Supports ECC type memory modules
. Supports PC3200 / 2700 / 2100 / 1600 DDR


When it says it "supports" PC3200 / 2700 / 2100 / 1600
does that mean that all it needs is 1600, and you wont get any real benefit
from the higher speed ram
or does it mean that you will get more performance out of the higher speed
ram.

If I have the Opteron 244 (1.8mhz) which Ram should I have to get the best
performance out of the Processor.
Click to expand...

You will see a real speed benefit from the higher speed RAM. Check the AMD
site to see what speeds the 244 support, it will handle at least PC2700
and probably PC3200.
 
arnie said:
If I have the Opteron 244 (1.8mhz) which Ram should I have to get the
best performance out of the Processor.
Click to expand...

To get the best performance from your memory and CPU interface, when using
the 1.8 GHz processor, you should get either DDR 266 (2nd choice) or DDR 400
(1st choice) memory. The DDR 333 memory will be out of phase with the CPU
clock. The same is true for CPUs at 2.2 GHz. CPUs at 2.1 GHz support DDR
400.

A CPU at 2.0 GHz will support all memory speeds through DDR 400. AFAIK, the
AMD64 processors do not presently support DDR2 at any speed grade, but
hopefully this will change soon.
 
Back
Top