Turtlebeach Montegro DDL SPIDIF

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Having problems getting the card back into 5.1 mode after a bad AutoUpdate
driver install (Wrong driver).
Unable to get the Montegro DDL control panel to start since Vista Upgrad
from XPpro ("Could not find DDL device").
Audio settings allow 6.1to be set , but the Optical (SPDIF) only shows 2.1
on the reciever mode display (and the 6.1 test sounds all come from the front
speakers only (at different levels for rear test tones)).
No Vista specific driver at Turtlebeach.
 
Was the card working properly before you upgraded the driver? If so, try a
driver rollback. Instructions are repeated on the forum numerous times for
accomplishing this.

Hope it works. Otherwise you'll have to wait for Turtlbeach to support
their card properly.
 
Yes it was working.
Properly, probabbly no. I always had to open the DDL control
application (then I could just close it, doing nothing else) to get it to
ANY output via the SPIDIF .
Vista seems to use the port fine until the wrong driver. I/Vista messed up
the roll-back. :/
I am going to try another XP->Vista upgrade on this system with a few non
supported network components removed FIRST.
Thanks
 
Back
Top