Stephan Grossklass said:
Rajiv said:
Hi folks,
I currently have a P2B-F motherboard running a AOpen slotkey with a Socket
370 Pentium-III 800. I've got a Tualatin processor which I tried to use
rather than the Pentium-III, but with no luck.
From looking browsing through google, I suspect that the pinouts on the
Tualatin processor are different from the Pentium-III processors.
Does anyone know the mod required to get this to work ?
First off, does the slot adapter have a voltage clamp chip on it? From
what I remember, that's pretty much a necessity for a Tualatin mod to
work. As for the mod itself, search for Tualatin mods on the MSI 6905
Master, Asus S370-DL [1] and such. If your current adapter should be a
no-go, Slot-Ts and other cheapo Tualatin slot adapters no longer cost a
fortune these days.
Stephan
[1] like the one found here:
http://tipperlinne.com/p2bmod
A Slot-T will work, as long as the motherboard regulator can produce
the 1.5V Vcore to run the processor.
http://www.upgradeware.com/english/product/slott/slott.htm
I got mine many eons ago, from this site:
http://www.bytewizecomputers.com/products/7/9/104/1048
Using that thing is a lot easier than hacking up an existing
adapter.
For more info, Roland's FAQ is good:
http://homepage.hispeed.ch/rscheidegger/p2b_procupgrade_faq.html
"P2B-F rev. 1.00 with a new voltage regulator chip have pcba
numbers A0A, A0B, A1A, A1B, A2A, A2B, A33, A34, A43, A44,
A53, A54"
Looking at the voltage regulator chip part number, can tell you
whether a request for 1.5V power, can be met by your board. Since
the P3-800 worked for you, chances are the Vreg is the right
type, but read the above FAQ and have a look at the parts on
your board, to be absolutely sure. I actually changed out the
voltage regulator chip on my P2B-S, in order to be able to use
the ultra-cheap Slot-T adapter.
Paul