Support for shutdown from UPS signal?

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Windows XP had support in the Power options area of Control Panel for
UPS-initiated shutdown; I have one of the classic APC Back-UPS that uses a
serial port to connect to the computer and signal it to shut down if the AC
power fails. I cannot find settings for this in Vista RC2. Will I need to
resort to running Power Chute Plus, will it run on Vista? Can't seem to find
any thing in the help and support for UPS other than its definition.
 
Ron Holder said:
Windows XP had support in the Power options area of Control Panel for
UPS-initiated shutdown; I have one of the classic APC Back-UPS that uses a
serial port to connect to the computer and signal it to shut down if the
AC
power fails. I cannot find settings for this in Vista RC2. Will I need to
resort to running Power Chute Plus, will it run on Vista? Can't seem to
find
any thing in the help and support for UPS other than its definition.
Click to expand...



Parallel port UPS devices will not interface with Vista it seems. Consider
that the parallel interface has been gone for about 3-4 years now. I am now
considering getting a newer UPS to handle this situation myself.

The UPS itself works fine. You just can not configure it at all.

--

Regards,

Richard Urban
Microsoft MVP Windows Shell/User

Posted using Vista RC2 5744

(For email, remove the obvious from my address)

Quote from George Ankner:
If you knew as much as you think you know,
You would realize that you don't know what you thought you knew!
 
Back
Top