C
CHANGE USERNAME TO westes
On both the StorageTek L180 and L700 tape libraries, I have noticed that if
the library is run in an environment with a high ambient temperature (over
about 80-to-85 degrees), you start to get problems with tapes getting stuck
in the gripper. Once this happens, the library fails initialization right
after exercising the gripper, and the FSC code refer to Z and Theta
problems.
Power off the library for five minutes and the library can pass
initialization, but after a short time period if you re-initialize it will
fail again, in the identical way.
As I said, I have seen this on both the L180 and L700, and I test quite a
few of both of these models.
Has anyone else observed this?
the library is run in an environment with a high ambient temperature (over
about 80-to-85 degrees), you start to get problems with tapes getting stuck
in the gripper. Once this happens, the library fails initialization right
after exercising the gripper, and the FSC code refer to Z and Theta
problems.
Power off the library for five minutes and the library can pass
initialization, but after a short time period if you re-initialize it will
fail again, in the identical way.
As I said, I have seen this on both the L180 and L700, and I test quite a
few of both of these models.
Has anyone else observed this?