stop error: ntfs.sys

  • Thread starter Thread starter Nitin Parmar
  • Start date Start date
N

Nitin Parmar

I Have seagate cheeta 10k rpm with adaptec 19160/29160 scsi card in my
pc.

it run vey fine.

Now a week before I first Time got error. i. e.
Stop : 0x00000050, page fault in nonpaged area
address BFF21F1F BASE AT BFEB8000,DATA STAMP 3919B3DA - NTFS.SYS IN
W2k SERVER & WIN XP ALSO.

I TYE TO CHANGE MY RD RAM THEN ALSO THE SAME ERROR COMMING.

At first I began seeing strange application errors, my apps would

I WANT TO TAKE backups of my most vital data ,so tried a
fresh install, but every time the process came to a certain point;
"starting win2k" it threw the BSOD at me giving "x050 page fault in
nonpaged area etc. ntfs.sys"

Now this is a general error message that could contain anything so I
stripped the system bare of peripherals (all but scsi and video) and
it gave me the same BSOD.

I eventually figured that it had to be something with the disk maybe
it had corrupted the filesystem beyond recognition or?
I tried a clean install on the IDE disk and had the exact same problem
if I made it load the scsi driver during install.
Then I did an install without the seagate hooked up at all and I was
actually able to get the system booted with the seagate attached.
Then aiso it give me same problem

my pc config.
P IV 1.7 GHZ (INTEL)
D850MV INTEL ORIGINAL M.B.
512 MB RD RAM
17 GB SCSI ULTRA 1 H.D.D. (10K RPM)
AGP 32 MB VGA CARD
ADAPTEC 19160/29160 SCSI CONTROLLER

PL. GIVE ME SOLUTION IF ANY ONE HAVE .
THANKS
NITIN
 
There is a bug in ntfs plus data corruption on that volume. You should boot
Win 98/ME, load up sysinternal.com's ntfs reader, and copy the files to FAT32.

| I Have seagate cheeta 10k rpm with adaptec 19160/29160 scsi card in my
| pc.
|
| it run vey fine.
|
| Now a week before I first Time got error. i. e.
| Stop : 0x00000050, page fault in nonpaged area
| address BFF21F1F BASE AT BFEB8000,DATA STAMP 3919B3DA - NTFS.SYS IN
| W2k SERVER & WIN XP ALSO.
|
 
Back
Top