R
rupart
Hello gurus,
I get the above error..the server was running perfectly
fine(in production) until lately where it rebooted
unexpectedly with above error...
According to microsoft(below) it could be newly installed
hardware...but we never installed any new h/w... thus the
article below doesnt help much..Other tips is highly
appreciated:
************MS ARTICLE *******************************
Error Message:
STOP: 0x00000006 (parameter, parameter, parameter,
parameter) INVALID_PROCESS_DETACH_ATTEMPT
Explanation:
This is a Windows 2000 Executive character-mode STOP
message. It indicates a problem with an owned mutex or an
unclean asynchronous procedure call (APC) state.
User Action:
If this is the first time you have booted after installing
new hardware, remove the hardware and boot again. Check
the Microsoft Hardware Compatibility List to verify that
the hardware and its drivers are compatible with Windows
2000. For information about the hardware, contact the
supplier. If you are installing Windows 2000 for the first
time, check the Windows 2000 system requirements,
including the amount of RAM and disk space required to
load the operating system. Also, check the Hardware
Compatibility List to verify that the system can run
Windows 2000. If Windows 2000 is loaded and no new
hardware has been installed, reboot with recovery options
set to create a dump file. If the message continues to
appear, select the Last Known Good option when you reboot.
If there is no Last Known Good configuration, try using
the Emergency Repair Disk. If you do not have an Emergency
Repair Disk, contact your technical support group
********************END MS ARTICLE*************************
I get the above error..the server was running perfectly
fine(in production) until lately where it rebooted
unexpectedly with above error...
According to microsoft(below) it could be newly installed
hardware...but we never installed any new h/w... thus the
article below doesnt help much..Other tips is highly
appreciated:
************MS ARTICLE *******************************
Error Message:
STOP: 0x00000006 (parameter, parameter, parameter,
parameter) INVALID_PROCESS_DETACH_ATTEMPT
Explanation:
This is a Windows 2000 Executive character-mode STOP
message. It indicates a problem with an owned mutex or an
unclean asynchronous procedure call (APC) state.
User Action:
If this is the first time you have booted after installing
new hardware, remove the hardware and boot again. Check
the Microsoft Hardware Compatibility List to verify that
the hardware and its drivers are compatible with Windows
2000. For information about the hardware, contact the
supplier. If you are installing Windows 2000 for the first
time, check the Windows 2000 system requirements,
including the amount of RAM and disk space required to
load the operating system. Also, check the Hardware
Compatibility List to verify that the system can run
Windows 2000. If Windows 2000 is loaded and no new
hardware has been installed, reboot with recovery options
set to create a dump file. If the message continues to
appear, select the Last Known Good option when you reboot.
If there is no Last Known Good configuration, try using
the Emergency Repair Disk. If you do not have an Emergency
Repair Disk, contact your technical support group
********************END MS ARTICLE*************************