SOFTWARE file corrupt - windows wont start - help!!

  • Thread starter Thread starter sgeelen
  • Start date Start date
S

sgeelen

I recently couldn't get the program Easy Creator CD to
work on my machine (wouldn't run when started the .exe
file). So I repaired the Easy Creator CD using the
installation CD but this didn't fix the problem. SO to
fix the problem I uninstalled Easy Creator CD and removed
all references to the program from the registry using
regedit. After restarting the machine I then re-installed
Easy Creator CD.
I then burnt a CD which crashed the machine when the CD
was 99% complete.

I then restarted the machine the next morning and windows
2000 wouldn't load and crashes continually.
A statement mentioning something about the SOFTWARE file
being corrupt appears just before the machine crashes.

Do you know of any methods to get windows running again
without losing the data on the hard drive.

Thanks
Stefan
 
Can you boot to safe mode and remove the software and/or look through the
event logs?
 
If the software hive is corrupt, it may be possible to rename the software
hive found in;
%windir%\system32\config\software
to software.old
then copy the most recent backup found in
%windir%\repair\regback
as
%windir%\system32\config\software

If that fails you can copy/ use the file
%windir%\repair\software
This file is an image of the hive at the time the OS was installed, so you'd
have to reinstall all software. This being the case you might just as well
blow it away and start a new install. (note: this would at least allow you
to start the OS to make any necessary backups prior to wiping the drive.)

To start the Recovery Console, start the computer from the Windows 2000
Setup CD or the Windows 2000 Setup floppy disks. If you do not have Setup
floppy disks and your computer cannot start from the Windows 2000 Setup CD,
use another Windows 2000-based computer to create the Setup floppy disks.
Press ENTER at the "Setup Notification" screen. Press R to repair a Windows
2000 installation, and then press C to use the Recovery Console. The
Recovery Console then prompts you for the administrator password. If you do
not have the correct password, Recovery Console does not allow access to the
computer. If an incorrect password is entered three times, the
RecoveryConsole quits and restarts the computer. Once the password has been
validated, you have full access to the Recovery Console, but limited access
to the hard disk. You can only access the following folders on your
computer: %systemroot% and %windir%
 
Back
Top