How are you installing? Make sure your system bios is Windows 2000
compatible. To do a clean install, either boot the Windows 2000 install
CD-Rom or setup disks. The set of four install disks can be created from
your Windows 2000 CD-Rom; change to the \bootdisk directory on the CD-Rom
and execute makeboot.exe (from dos) or makebt32.exe (from 32 bit) and follow
the prompts.
When you get to the point, delete the existing NTFS and or other partitions
found. After you delete the partition(s) abort the install, then again
restart the pc booting the CD-Rom or setup disks to avoid unexpected drive
letter assignments with your new install.
You didn't mention the drive controller (possibly SCSI, or ultra DMA, or
ATA100, or raid, or serial ATA), but you may need to boot the Windows 2000
setup disks or CD-Rom and *F6* very early and very important (at setup is
inspecting your system) in the setup to prevent drive controller detection,
and select S to specify additional drivers. Then later you'll be prompted to
insert the manufacturer supplied Windows 2000 driver for your drive's
controller in drive "A"
If you wait and then S to specify additional drivers, then it may be too
late as Windows 2000 Setup at this point may have already assigned the
resources your drive's controller is wanting to use.
--
Regards,
Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft MVP [Windows NT/2000 Operating Systems]
Microsoft Certified Professional [Windows 2000]
http://www.microsoft.com/protect
| Get this error while trying to install Win2K pro:
|
| ntkrnlmp.exe could not be loaded. The error code is 4
