setting sloket and P2B mainboard for celeron 667MHz ?

  • Thread starter Thread starter tolman
  • Start date Start date
T

tolman

Hi!
I have Asus P2B mainboard rev. 1.04 with BIOS upgraded. It has voltage chip
regulator capable for 1,8 V and above. I bought MS 6902 ver. 2 fc-pga
adapter and celeron 667MHz. Adapter has auto settings enabled. How should i
set jumpers on the mainboard (voltage and fsb) to run this celeron?
 
tolman said:
Hi!
I have Asus P2B mainboard rev. 1.04 with BIOS upgraded. It has voltage chip
regulator capable for 1,8 V and above. I bought MS 6902 ver. 2 fc-pga
adapter and celeron 667MHz. Adapter has auto settings enabled. How should i
set jumpers on the mainboard (voltage and fsb) to run this celeron?
Click to expand...

As you may have noticed, the P2B has no voltage jumpers, and the stock
FSB of that CPU is 66 MHz (though you could, of course, try
overclocking, but please keep the PCI clock in mind to avoid data loss).
You will have to set the voltage to 1.80 V on the 6905 Master in order
to get this working.

Stephan
 
Stephan Grossklass said:
As you may have noticed, the P2B has no voltage jumpers, and the stock
FSB of that CPU is 66 MHz (though you could, of course, try
overclocking, but please keep the PCI clock in mind to avoid data
loss). You will have to set the voltage to 1.80 V on the 6905 Master
in order to get this working.

Stephan
Click to expand...

Thanks for advise. You are right :). There is no voltage jumpers on Asus
P2B. One more question. When i set the jumper on 6905 for 1,8V is that mean
that CPU will be working on 1,8 V (normally it works on 1,6 V or
something)?
 
Back
Top