Set the computer name in Target Designer.

  • Thread starter Thread starter LeonardoITA
  • Start date Start date
L

LeonardoITA

Hello,

I'm developing an xp embedded image, the problem is about setting the
machine name inside the Target Designer. Is it possible? How can I do?

Thank you very much.
 
You can setup the name under the System Identification settings in the
Computers component. Typically the computers component is one of the
following: ACPI Multiprocessor PC, ACPI Uniprocessor PC, Advanced
Configuration and Power Interface (ACPI) PC, Compaq SystemPro Multiprocessor
or 100% Compatible, MPS Multiprocessor PC, MPS Uniprocessor PC, or Standard
PC. The computer component is found by Target Analyzer (TAP.exe) and it
should already be in your configuration.

--
Regards,

Sean Liming
www.sjjmicro.com / www.seanliming.com
Book Author - XP Embedded Advanced, XP Embedded Supplemental Toolkit
 
Back
Top