M
Macro
Have a computer running W2K Server w/sp2, Workstations on
W2K Pro. Server is DHCP server for network, scope of
10.0.0.3~254. Linksys router IP of 10.0.0.20 (Hard
assigned in router. DHCP disabled) Linksys connected to
internet thru cable modem to SBC DSL (PPoE). all clients
can access internet ok. Server IP address of 10.10.1.1
mask 255.0.0.0. Thru blind stabs and trial & error of
router management services (?) was able to get to a point
that I could access the router set-up html thru IE. could
not get server to access internet. do I have to set up a
static route to access internet across the sub-nets? If
the terminology is mixed up, please excuse, Inherited this
system and am new to W2K server setups.
W2K Pro. Server is DHCP server for network, scope of
10.0.0.3~254. Linksys router IP of 10.0.0.20 (Hard
assigned in router. DHCP disabled) Linksys connected to
internet thru cable modem to SBC DSL (PPoE). all clients
can access internet ok. Server IP address of 10.10.1.1
mask 255.0.0.0. Thru blind stabs and trial & error of
router management services (?) was able to get to a point
that I could access the router set-up html thru IE. could
not get server to access internet. do I have to set up a
static route to access internet across the sub-nets? If
the terminology is mixed up, please excuse, Inherited this
system and am new to W2K server setups.