SDI doesn't work

  • Thread starter Thread starter Daniele
  • Start date Start date
D

Daniele

I have a diskless system, so:
- I have built my image with target designer;
- i putted it into drive C: of a reference device (i.e. an hard disk);
- I FBAing the image until a message of reseal was shown to me;
- I booted again from disk because I have to tuning something that
cannot go well through FBA;
- I run "fbreseal --keepall";
- I created sdi file;

when the target machine try to start show me the message:
"Windows could not start due to an error while booting from a RAMDISK.
Windows failed to open RAMDISK image." I check the locatin and the name
of sdi and they are right.

My sdi is 990 MB and the ram is 2 GB. I try to make a 600MB sdi, but
nothing change.

Any help will be appreciated.

Daniele
 
Daniele ha scritto:
I have a diskless system, so:
- I have built my image with target designer;
- i putted it into drive C: of a reference device (i.e. an hard disk);
- I FBAing the image until a message of reseal was shown to me;
- I booted again from disk because I have to tuning something that
cannot go well through FBA;
- I run "fbreseal --keepall";
- I created sdi file;
Click to expand...
What is the maximum limit for diskless image? Is it half of my RAM?
 
1. Did you include the RAM Driver component?
2. Try starting simpler to prove that the system works, don't do System
Cloning.


Regards,

Sean Liming
www.sjjmicro.com / www.seanliming.com
Book Author - XP Embedded Advanced, XP Embedded Supplemental Toolkit
 
Back
Top