Scanner and Camera Wizard doesn't show up in pictures autoplay win

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I had been using the Scanner and Camera Wizard for over 1 year without
problems; recently, however, it stopped showing up as an option when I insert
my CF card into the multicard reader on my PC. I did recently load Rollup2
for MCE2005, but I don't know if that has anything to do with my problem.

The autoplay does work, it just show only WE and Take No Action as the
options. Before I had a full list of choices.

Thanks,
Ian
 
Ian said:
I had been using the Scanner and Camera Wizard for over 1 year without
problems; recently, however, it stopped showing up as an option when I
insert
my CF card into the multicard reader on my PC. I did recently load
Rollup2
for MCE2005, but I don't know if that has anything to do with my problem.

The autoplay does work, it just show only WE and Take No Action as the
options. Before I had a full list of choices.

Thanks,
Ian
If I were faced with this prpblem, I would just use Explorer to get the
images off the card..
Jim
 
Connect your camera. Open My Computer. Your camera will be listed as a
Removable Drive. Usually listed under your CD drive. Right click on it and
click on Properties. Click on The Autoplay tab and select photos and reset
the default.
 
Hi, thanks for you reply. I didn't get the Autoplay option when I connected
my camera. I only had tabs for "General", "Events", "Color Management". The
Autoplay did come up, but only with Camera & Scanner Wizard, and Word.

When I did this for my Media Card in the multicard reader, I receive the
MCE2005 and Take No Action as the options from Autoplay. I could not restore
defaults back the original list of options.

Thanks,
Ian
 
Back
Top