You'll want to boot the Windows 2000 setup disks or CD-Rom. The set of four
install disks can be created from your Windows 2000 CD-Rom; change to the
\bootdisk directory on the CD-Rom and execute makeboot.exe (from dos) or
makebt32.exe (from 32 bit) and follow the prompts.
Then *F6* very early and very important (at setup is inspecting your system)
in the setup to prevent drive controller detection, and select S to specify
additional drivers. Then later you'll be prompted to insert the manufacturer
supplied Windows 2000 driver for your serial ATA controller in drive "A"
If you wait and then S to specify additional drivers, then it may be too
late as Windows 2000 Setup at this point may have already assigned the
resources your drive's controller is wanting to use.
When you get to the point, delete the existing NTFS and or other partitions
found. After you delete the partition(s) abort the install, then again
restart the pc booting the CD-Rom or setup disks to avoid unexpected drive
letter assignments with your new install.
--
Regards,
Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect
:
| Hello, i have a new kx18d pro2 with a SATA HDD , when
| after formatting i try to load W2K i get a message
| saying "setup did not find any HDD installed on my
| computer".NB Im not using IDE for HDD only IDE for CD-Roms
| I only whish to use SATA Raid HDD[i will put in a second
| SATA Raid HDD in the future]
| Please advise
|
| Regards Tony
