SATA Drivers for P4C800-E m/b

  • Thread starter Thread starter JDR
  • Start date Start date
J

JDR

Where to find and how to install SATA Drivers for P4C800-E?

Hi, I have extracted from CD (P4C800-E) Integrated drivers
used F6 and directed Setup to Floppy - and nothing happened.
Still Set up cannot see the two SATA Drives. Any tips will be
appreciated.

Jdr
 
JDR said:
Where to find and how to install SATA Drivers for P4C800-E?

Hi, I have extracted from CD (P4C800-E) Integrated drivers
used F6 and directed Setup to Floppy - and nothing happened.
Still Set up cannot see the two SATA Drives. Any tips will be
appreciated.
Click to expand...

It takes a while before the effect of pressing F6 and inserting
the floppy actually does anything - setup will continue as if nothing
happened for quite some time.
HTH
 
I have that board, when you press F6, the drivers are not loaded right away,
you get a message later on to press "S" I believe to install the SATA
drtiver
 
I do not recall doing all that, F6, floppy, etc. but my 200 gb SATA is
running ok. Could this mean it is running slow?
Jime

News Reeder said:
I have that board, when you press F6, the drivers are not loaded right
away, you get a message later on to press "S" I believe to install the SATA
drtiver
Click to expand...
 
jime said:
I do not recall doing all that, F6, floppy, etc. but my 200 gb SATA is
running ok. Could this mean it is running slow?
Jime
Click to expand...

Thank you to ALL Contributors to my topic.
Shortly after I sent this message I managed to
start and proceed with fresh installation on this PC
I am using now. BTW for the first time I used
the Genie Backup Manger 6 for my job. The software came with
November PCW Magazine and it was free ( ltd edition).
This Genie worked really as the Genie. After installation finished
I was back with everything in tact - in about an hour.

Regards to All -

Jdr
 
Back
Top