Sapphire Atlantis 9800 - Control Panel. . .

  • Thread starter Thread starter Wayne Youngman
  • Start date Start date
W

Wayne Youngman

Hi,

just getting to grips with my ATI control panel, didn't touch it since I did
my clean install. I was wondering how other people have theirs set-up?. I
kinda figured it was a case of leave it set at defaults, and do all the
adjusting from within the game, but of course not all games have advanced
graphic options like FSAA, AF etc. . .

This is my D3D tab:

www.waynes.spamtrap.btinternet.co.uk/My_ATI_Control_Panel.gif

This is how it was set-up by default, is that 2x FSAA and 2x AF enabled?.
Should I whack up the lever at the top to make it do FSAA/AF in older games?

Thanks for any feedback. Initially I was wondering if these settings made a
big impact on benchmarks, but when I lowered them all and ran 3DMark03 my
score came out lower than when this tab as set at default?
--
Wayne ][

Barton (AQXEA) XP2500+ @ 2.2GHz (10x220) - 1.75vCore
CoolerMaster Aero 7 Lite - 3,200rpm
ABIT NF7-S (v2.0 - BIOS#14)
512MB Dual TwiSTER PC3500 @ DDR440 (8,3,3,2.0 - 2.8v)
Sapphire Atlantis 9800 - 3.3ns Samsung
240GB (2x120GB) WD-SE SATA RAID-0 (16k Stripe)
Antec SX630II Mini-Tower Case Inc 300w PSU
WinXP-PRO-SP1
Cat 3.7 - DX9.0b
 
I uncheck 'application preference' and turn FSAA and AF all the way up :)
For OGL, I only turn AF up to 8x. I get major lag, in OGL games, otherwise.
But, you have a kickass card, so you might get away with it :P


-
Wayne Youngman stood up at show-n-tell, in
[email protected], and said:
 
Likewise, I unchecked application preference and went with 4xAA and 8xAF in
all my 3d apps. I have yet to see the app where I would need to turn these
settings down. UT2003 runs like butter at these settings on my 2800+ XP and
9800.

JK
 
Back
Top