Samsung ML-2010

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Hello everyone. Version of Windows - Vista RC1 Version 5600

I installed my printer that I purchased today. When Windows Add Hardware
completes the installation, it tells me that I have blocked Windows NT 4.0
drivers. How can I unblock the NT 4.0 drivers?

Thanks in advance
 
=?Utf-8?B?SGFtX1JhZGlvX09wZXJhdG9y?=
Hello everyone. Version of Windows - Vista RC1 Version 5600

I installed my printer that I purchased today. When Windows Add
Hardware completes the installation, it tells me that I have blocked
Windows NT 4.0 drivers. How can I unblock the NT 4.0 drivers?

Thanks in advance
Click to expand...

I would start by re-checking on the install disk to see if you can
explicitly install a W2K or XP driver - could you have accidentally
installed from an NT4 sub-directory?

However, you probably need to contact Samsung (or look on their website) to
ask for an updated driver - what you need is a user-mode driver which
probably describes itself as supporting Win2000 or XP.
NT4 printer drivers are kernel mode and kernel mode printer drivers are no
longer supported by Vista. (Kernel mode printer drivers have been
deprecated since Windows 2000 added support for user mode printer drivers).

Judy
 
I fiexed the problem. Since there are no drivers for the 64 bit version of
Vista, I reinstalled Vista on the 32 bit platform, then the printer was
acknowledged. It is a shame; I prefer 64 bit version. I truly hope that 64
bit is improved for its release later this month.
 
OK, coincidence or what?

I am also a Ham Radio Operator and Have a Samsung ML-2010 with driver
issues.

When using the X86 version of Vista, regardless of build...I use the Factory
CD based drivers for the printer.
When using the X64 version of Vista, again...regardless of build number...I
end up using or should I say Vista selects Dell 1100 drivers for the
printer.

Either way, the printer works fine with the drivers mentioned.

N2EAL,
Gary MCSE
 
If you are curious, my callsign is VE9CBC.
--
Yours truly,

A Helping Hand


Gary MCSE said:
OK, coincidence or what?

I am also a Ham Radio Operator and Have a Samsung ML-2010 with driver
issues.

When using the X86 version of Vista, regardless of build...I use the Factory
CD based drivers for the printer.
When using the X64 version of Vista, again...regardless of build number...I
end up using or should I say Vista selects Dell 1100 drivers for the
printer.

Either way, the printer works fine with the drivers mentioned.

N2EAL,
Gary MCSE
Click to expand...
 
Hi, a vista driver is now available on the samsung website for printer
ml-2010 , hope this helps...byee

Ham_Radio_Operator said:
If you are curious, my callsign is VE9CBC.
Click to expand...
 
Back
Top