After booting into the Safe Mode with the Command Prompt.
And when you're done using the command prompt...
Close the command prompt by typing:
exit
Hit the Enter key.
Or...
Click on the Close [X].
Or...
Start the Windows shell.
Type:
explorer
Hit the Enter key.
Or...
Open Task Manager...
Ctrl + Shift + Esc | File | New Task (Run...) | Type: explorer | OK |
Either way, this warning will come up.
--------
Desktop Warning
Windows is running in safe mode.
This special diagnostic mode of windows enables you to fix a
problem which may be caused by your network or hardware
settings. Make sure these settings are correct in Control Panel, and
then try starting Windows again. While in safe mode, some of your
devices may not be available.
To proceed to work in safe mode, click Yes. If you prefer to use
System Restore to restore your computer to a previous state, click
No.
--------
Also, when done doing whatever, you need to open msconfig again...
Open Task Manager...
Ctrl + Shift + Esc | File | New Task (Run...) | Type: msconfig | OK |
UNSelect: /SAFEBOOT under the boot.ini tab | Click Apply |
Under the General tab Select: Normal Startup - load all device drivers and
services | Click Apply and Close
Or...
Open Task Manager...
Ctrl + Shift + Esc | File | New Task (Run...) | Type: explorer | OK |
And open msconfig from Start | Run
Or Windows key + R to open the run box.
--
Hope this helps. Let us know.
Wes
MS-MVP Windows Shell/User
In