RTF control in reports

  • Thread starter Thread starter carbra
  • Start date Start date
C

carbra

I am using the Lebans RTF control (RTF2.ocx) in a form, and the attached
report is also design with the ActiveX control like the Lebans' A2K
RTF2Sample Release.mdb. The print out is deviding the lines in half on both
sides (the last line on p1 and the first line on p2). Is the a way of
controlling the print out from a report using then Active X control RTF2.ocx.
I have tryed the A2K2ReportUtilities.mdb but the reports includes the
testmemo and not the RTFcontrol.
 
This issue is created/controlled by the Access Report engine. Third Party
ActiveX controls have absolutely no control over where Access selects as a
Page Break.

There is no straightforward solution. In many cases, a small mod in the RTF2
control's placement in its report Section will resolve the issue. If not,
make sure there are not any other controls either immediately above or below
the RTF2 control.

--

HTH
Stephen Lebans
http://www.lebans.com
Access Code, Tips and Tricks
Please respond only to the newsgroups so everyone can benefit.
 
Back
Top