right click error

  • Thread starter Thread starter charlie
  • Start date Start date
C

charlie

I hope this is the right group. Win xp pro, right click
on any folder, file or shortcut and get an windows
explorer error and closes the file. Doesn't do thid in
the safe mode or when I uninstalled ms office 2k. Lots of
drivers to look thru, has anyone had this problem.

thanks

charlie
 
First, be sure your antivirus software has the latest definitions and run a
virus scan.

Second, download, install and run Ad Aware:
www.lavasoftusa.com
Note: you should always be well backed up before running an application of
this type.

If your system is clear of viruses, open Control Panel, open System, go to
the Advanced tab, click Settings under Startup and Recovery, remove the
check from "Automatically Restart" under System Failure. This will cause
the system to blue screen instead of restarting on errors and the
information on the blue screen may give a clue as to the source of the
issue.

Open Control Panel, open Administrative Tools, open Event Viewer, look for
errors corresponding to the crash, double click the error, the information
contained within may give a clue as to the
source of the problem. If you don't understand the information inside, the
third button down in that dialog box will copy the information,
you can then paste it into a message and post it here and maybe we can
figure out what is going on.

Assuming you have an XP CD and not a recovery CD, place the XP CD in the
drive, when the setup screen appears, select "Check System Compatibility,"
the report it generates may point to problem hardware or software on your
system. If you do not have an XP CD, you can download this application
known as the Upgrade Advisor from the following site:
http://www.microsoft.com/windowsxp/pro/howtobuy/upgrading/advisor.asp
Note: If you have access to a broadband connection it might be best to
download using that as this is a rather large download.

Check for the latest drivers for your hardware, especially your graphics
card and soundcard and all peripherals connected to your system. Do not use
Windows Update for this, go to the device manufacturer's web sites and if
you install updated drivers, ignore the message about drivers being unsigned
by Microsoft. *Before installing any drivers, be sure you are well backed
up and it's probably a good idea to manually create a restore point in
System Restore in case you have problems as a result of the driver update
and note, System Restore is not a substitute for a backup. Start\All
Programs\Accessories\System Tools\System Restore
 
-----Original Message-----
First, be sure your antivirus software has the latest definitions and run a
virus scan.

Second, download, install and run Ad Aware:
www.lavasoftusa.com
Note: you should always be well backed up before running an application of
this type.

If your system is clear of viruses, open Control Panel, open System, go to
the Advanced tab, click Settings under Startup and Recovery, remove the
check from "Automatically Restart" under System Failure. This will cause
the system to blue screen instead of restarting on errors and the
information on the blue screen may give a clue as to the source of the
issue.

Open Control Panel, open Administrative Tools, open Event Viewer, look for
errors corresponding to the crash, double click the error, the information
contained within may give a clue as to the
source of the problem. If you don't understand the information inside, the
third button down in that dialog box will copy the information,
you can then paste it into a message and post it here and maybe we can
figure out what is going on.

Assuming you have an XP CD and not a recovery CD, place the XP CD in the
drive, when the setup screen appears, select "Check System Compatibility,"
the report it generates may point to problem hardware or software on your
system. If you do not have an XP CD, you can download this application
known as the Upgrade Advisor from the following site:
http://www.microsoft.com/windowsxp/pro/howtobuy/upgrading /advisor.asp
Note: If you have access to a broadband connection it might be best to
download using that as this is a rather large download.

Check for the latest drivers for your hardware, especially your graphics
card and soundcard and all peripherals connected to your system. Do not use
Windows Update for this, go to the device manufacturer's web sites and if
you install updated drivers, ignore the message about drivers being unsigned
by Microsoft. *Before installing any drivers, be sure you are well backed
up and it's probably a good idea to manually create a restore point in
System Restore in case you have problems as a result of the driver update
and note, System Restore is not a substitute for a backup. Start\All
Programs\Accessories\System Tools\System Restore


--
Michael Solomon MS-MVP
Windows Shell/User
Backup is a PC User's Best Friend
DTS-L.Org: http://www.dts-l.org/




.
Click to expand...
Thanks for your reply. I went down your checklist, no
viruses or ad spyware. Unchecked the "automatically
restart" box. Right clicked a word file and not blue
screen. Just a box asking to send or don't send error
report. Went to event viewer could copy but couldnt paste
by control v, crash. Finally opened new text file and
pasted thru edit. Dragged the file to a floppy to run on
another machine. Did the xp disk and removed the easy cd
creator. No luck. Below is the error message if this
helps.
Thanks in advance

Charlie

Event Type: Error
Event Source: Application Error
Event Category: None
Event ID: 1000
Date: 4/29/2004
Time: 9:07:05 PM
User: N/A
Computer: ENGINEERING3
Description:
Faulting application explorer.exe, version 6.0.2800.1106,
faulting module cscui.dll, version 5.1.2600.1106, fault
address 0x00018102.

For more information, see Help and Support Center at
http://go.microsoft.com/fwlink/events.asp.
Data:
0000: 41 70 70 6c 69 63 61 74 Applicat
0008: 69 6f 6e 20 46 61 69 6c ion Fail
0010: 75 72 65 20 20 65 78 70 ure exp
0018: 6c 6f 72 65 72 2e 65 78 lorer.ex
0020: 65 20 36 2e 30 2e 32 38 e 6.0.28
0028: 30 30 2e 31 31 30 36 20 00.1106
0030: 69 6e 20 63 73 63 75 69 in cscui
0038: 2e 64 6c 6c 20 35 2e 31 .dll 5.1
0040: 2e 32 36 30 30 2e 31 31 .2600.11
0048: 30 36 20 61 74 20 6f 66 06 at of
0050: 66 73 65 74 20 30 30 30 fset 000
0058: 31 38 31 30 32 0d 0a 18102..
 
If this is a relatively recent issue, you might try using System Restore to
take you back to a time when this worked properly. Start\All
Programs\Accessories\System Tools\System Restore. If that doesn't resolve
it, try the information below.

The following assumes you have an actual XP CD as opposed to a restore CD or
restore partition supplied by your PC manufacturer.

Go to Start, type sfc /scannow in the run box and press enter. Note, there
is a space between sfc and the forward slash. You will be asked for your XP
CD. Be aware, upon inserting the CD the XP setup screen may appear, this is
not a part of sfc /scannow, rather it is being invoked by autorun. Simply
minimize the screen and allow sfc to continue.

If the above fails to resolve the issue, try a repair install as follows:

Be sure you are well backed up in case there is a problem from which you are
unable to recover. NOTE, while a repair install should leave your data
files intact, if something goes wrong during the repair install, you may be
forced to start over and do a clean install of XP. If you don't have your
data backed up, you would lose your data should that eventuality occur.

Assuming your system is set to boot from the CD-ROM drive, boot with the XP
CD in the drive. If it isn't or you are not sure, you need to enter the
system's BIOS. When you boot the system, the first screen usually has
instructions that if you wish to enter setup press a specific key, when you
see that, do so. Then you will have to navigate to the boot sequence, if
the CD-ROM drive is not first line, set it first in the boot sequence. Save
your settings and exit with the XP CD in the drive. The system will reboot.

Boot from the CD. If your system is set to be able to boot from the CD, it
should detect the disk and give a brief message, during the boot up, if you
wish to boot from the CD press any key.

Once you have pressed a key, setup should begin. You will see a reference
asking if you need to load special drivers and another notice that if you
wish to begin the ASR (Automatic Recovery Console) depress F2. Just let
setup run past all of that. It will continue to load files and drivers.

Then it will bring you to a screen. Eventually, you will come to a screen
with the option to (1) setup Windows or (2) Repair Windows Installation
using the Recovery console.

The first option, to setup Windows is the one you want and requires you to
press enter. When asked, press F8 to accept the end user agreement. Setup
will then search for previous versions of Windows. Upon finding your
version, it will ask if you wish to Repair your current installation or
install fresh. Press R, that will run a repair installation. From there
on, follow the screens.
 
-----Original Message-----
First, be sure your antivirus software has the latest definitions and run a
virus scan.

Second, download, install and run Ad Aware:
www.lavasoftusa.com
Note: you should always be well backed up before running an application of
this type.

If your system is clear of viruses, open Control Panel, open System, go to
the Advanced tab, click Settings under Startup and Recovery, remove the
check from "Automatically Restart" under System Failure. This will cause
the system to blue screen instead of restarting on errors and the
information on the blue screen may give a clue as to the source of the
issue.

Open Control Panel, open Administrative Tools, open Event Viewer, look for
errors corresponding to the crash, double click the error, the information
contained within may give a clue as to the
source of the problem. If you don't understand the information inside, the
third button down in that dialog box will copy the information,
you can then paste it into a message and post it here and maybe we can
figure out what is going on.

Assuming you have an XP CD and not a recovery CD, place the XP CD in the
drive, when the setup screen appears, select "Check System Compatibility,"
the report it generates may point to problem hardware or software on your
system. If you do not have an XP CD, you can download this application
known as the Upgrade Advisor from the following site:
http://www.microsoft.com/windowsxp/pro/howtobuy/upgrading /advisor.asp
Note: If you have access to a broadband connection it might be best to
download using that as this is a rather large download.

Check for the latest drivers for your hardware, especially your graphics
card and soundcard and all peripherals connected to your system. Do not use
Windows Update for this, go to the device manufacturer's web sites and if
you install updated drivers, ignore the message about drivers being unsigned
by Microsoft. *Before installing any drivers, be sure you are well backed
up and it's probably a good idea to manually create a restore point in
System Restore in case you have problems as a result of the driver update
and note, System Restore is not a substitute for a backup. Start\All
Programs\Accessories\System Tools\System Restore


--
Michael Solomon MS-MVP
Windows Shell/User
Backup is a PC User's Best Friend
DTS-L.Org: http://www.dts-l.org/




.
Click to expand...
Also, get error message in safe mode.

charlie
 
Have you tried sfc /scannow or the repair install as I suggested and for
which I posted instructions?
 
-----Original Message-----
Have you tried sfc /scannow or the repair install as I suggested and for
which I posted instructions?

--
Michael Solomon MS-MVP
Windows Shell/User
Backup is a PC User's Best Friend
DTS-L.Org: http://www.dts-l.org/




.
Click to expand...
Thanks for all the help, tried everything to no avail.
Backed up and re-installed xp. Sure wish I could have
figured out what the heck caused all the problems. Again,
thanks for your help.

charlie
 
Back
Top