reset ink pad counter

  • Thread starter Thread starter Juan Carlos
  • Start date Start date
J

Juan Carlos

I have an old Epson Stylus color 460. How can I reset the ink pad counter?

When I put the printer on all lights begin blinking.

Thanks

Charlie from Forli Italy
 
Juan said:
I have an old Epson Stylus color 460. How can I reset the ink pad counter?

When I put the printer on all lights begin blinking.

Thanks

Charlie from Forli Italy
Click to expand...
This procedure works on a 740. According to the 460 service manual they
are very similar.
Turn the power OFF. Press and hold the Load/Eject and Cleaning buttons
while you tun ON the power. Release both buttons when the Paper Out LED
is flashing. Press and hold the Cleaning button for at least 10 seconds.
If that fails here is a link to download free software that can also
reset the counter.
http://ssclg.com/epsone.shtml
Where is Forli?
 
I believe the 460 and the 440 are the same models (just different
numbers based upon where they were sold)

I have the following sequence for the 440 model:

To set the printer into EEPROM management mode:

With printer OFF hold down Load/Eject+Cleaning buttons, while holding
press the ON SWITCH

This Enters the EEPROM Reset mode. (The Load/Eject LED blinks for a few
seconds.)

To Reset the EEPROM:

While the Load/Eject LED is blinking (for about 2 seconds), press down
the Cleaning switch for 10 seconds.

After 10 seconds, both Bk and CMY ink LEDs come ON simultaneously.

Confirming the both LEDs are ON, release the Cleaning switch. The
printer automatically starts initialization operation to reset the
specified addresses in the EEPROM

Once your printer has completed the initialization process, turn it off
via the power button.

When you next need to turn it on, it should function normally.


Keep in mind that if the ink pads are full, and you reset them without
replacement the ink could leak from the bottom of the printer.

Art
 
Back
Top