Reset Emulex NetJet card?

[Bob Eager]

I have an Emulex NetJet network card (fits lots of HP printers). I have
no documentation, and believe me I have tried!

I can get it to work after a fashion but need to set some options. I can
Telnet into it OK (although it'd be noce to be able to set the IP
address without doing so). However, soem functions require the 'su'
command, and I don't have the password (got it off eBay, yeah...)

There are two jumpers on the board; a three pin one which doesn'r have
any effect in any combination, and a two pin one that, if covered, gives
an error.

Anyone know how to reset these cards to defaults? Or, better still, have
a manual? Thanks...!

 

[William R. Walsh]

Hi!

I have an Emulex NetJet network card (fits lots of HP printers). I have
no documentation, and believe me I have tried!

What about:
http://web.archive.org/web/19980213050855/www.emulex.com/ts/ps/tsps.htm

It might be a starting point...many of the links point to a no longer
present FTP server, but I did see a setup procedure somewhere in there. You
might get *very* lucky and find the password still at the factory default.

William

 

[Bob Eager]

Hi!


What about:
http://web.archive.org/web/19980213050855/www.emulex.com/ts/ps/tsps.htm

It might be a starting point...many of the links point to a no longer
present FTP server, but I did see a setup procedure somewhere in there. You
might get *very* lucky and find the password still at the factory default.

Many thanks...I'll take a good look.

 

[Bob Eager]

Check this out. Emulex still hosts the files on this ftp site:

ftp://ftp.emulex.com/pub/

Thanks, but there's nothing there about resetting the card. The default
'su' password is 'system' (for the record) but that didn't work for me.