report layout

  • Thread starter Thread starter firecop1
  • Start date Start date
F

firecop1

Hi All
I have a report with a few short fields and a then a memo field that can
span from 1-3 or more pages depending on the incident.

I tried using a page break to insure that each record within the report will
start on a new page. This works fine but the problem is that I am getting a
blank page between each page of the report.

How and what do I have to adjust to correct the problem.

Also, I would like to place a button on my form that will enable me to print
a report on the current record only. How would I do this?

Thanks to all in advance for your help.

AJ
 
Open the toolbox and place a page break below the bottom control on the your
report's detail section.
 
I dont have any controls in my detail section as when I had them in tehir it
made it worse. I have all the controls up in the header which keeps them
together on the page although I get a blank page between each page (not each
record but each full page of info.\).
 
Suggest you start over and use the report wizard to build your report. Then
put a page break control below the last control in your report. It should be
directly below the last control with no or little space between the control
and page break.
 
Back
Top