remove user-lever security

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

What I did: I used the user-level security wizard. I printed the Security
wizard report. After the wizard was complete I no longer had access to my
data base. When I open the data base it asks for a name and password I enter
my name and password, from the instructions I have read it says to go to user
and group permissions. However this is grayed out and I can select it.

Question: How do I remove the security so that I can gain access once more?
 
Lazco said:
What I did: I used the user-level security wizard. I printed the
Security wizard report. After the wizard was complete I no longer had
access to my data base. When I open the data base it asks for a name
and password I enter my name and password, from the instructions I
have read it says to go to user and group permissions. However this
is grayed out and I can select it.

Question: How do I remove the security so that I can gain access once
more?
Click to expand...

Common mistake...Your password is blank when you try to go in the first
time. What many think is their password is actually the "Personal ID:" that
you entered when you created your new account. Try your account with a
blank password. If that lets you in THEN you can go into the security menu
to change your password.
 
Lazco,
I had a similar problem, if you haven't found a solution yet, read the
solution Joan Wild provided me with on october 11 Subject: How to remove
Security from Access 2002
Good luck, hope that works for you.
Marco
 
Back
Top