re booting

  • Thread starter Thread starter Mvic
  • Start date Start date
M

Mvic

My problem is that my computer insists on rebooting
especialy while trying to copy to CD or DVD, I have no
trouble transfering from my digital camcord to the
computer the problem is during the rendering or writing
to disk. I have used 3 different programs , Pinnacle
Studio 8, Unlead studio 8.12 and Windows movie maker,
The machins has also rebooted when listening to music and
occasionaly when copying a regular back up CD.
The computer 2.8 Intell 4 winXP, hard drive 160, RAM
256, Radeon 9200, Dazzel Dv drive
any suggestions
Maryv
 
Hello there,

Can I suggest that you check the cable plugged into your cd or DVD. A
common symptom of a bad connection in the 40pin 80 wire cable is that the
motherboard resets itself, and that gives the appearance of a windows
re-boot.

Very often the problem occurs with the cheaper grade of cable that does
not have a firm fit into either the motherboard or any of the drives. If you
turn your machine off when finished with it, that alone will add to the
problem, the heating and cooling of the machine causes a badly fitting cable
to work its way loose finally causing a bad connection.

How do I know? the above describes my problem of a few years back.....by
gently pressing on the plug you could feel it move back into place. It would
not fail again for several re-boots and the immediate solution was always
the same. .I replaced the cables and the problem disappeared permanently.

Best Wishes.....John Kelly
www.the-kellys.org
www.the-kellys.co.uk
 
Back
Top