RAID0

  • Thread starter Thread starter Norsk
  • Start date Start date
N

Norsk

I made a mistake and created a RAID0 of my 2 drives. Since the drives were
not the same size I lost disk space on the larger one.
Can I make a full system backup, remove the RAID0 defenitions from the
drives in BOIS and do a full system restore and that way get rid of the
RAID0, or will the restore process require RAID0 again?
Thanks for any help you can provide.
 
You can certainly "take down" the RAID and reset the BIOS to recognize each
physical drive. How you would proceed to set the system up again depends on
the type of backup(s) you made. Provide more detail and probably someone can
advise.

Tom
MSMVP 1998-2007
 
This is definitely possible, I've done it, and the opposite more than once,
what are you using for backup software?
 
I'm using the backup software that comes with Vista Ultima, Full System
Backup and will use the System CD to get the restore started as described in
the HELP for Full System Restore.
 
No experience on how that will work, I've use Ghost and Acronis True Image
successfully.
 
you can but......

if the partition on the raid-0 spans the entire size of the raid-0 combo you
have to shrink the partition the a bit smaller that the size of the disk you
want to restore to.

I found out the ugly way that the restore wants at least as much diskspace
as it had when the backup was made. Even if that amount was not totally
used.
 
Now that you mention that I remember discovering the same thing when I used
the Vista backup utility once, which is why I no longer use it.
 
Back
Top