RAID set: copy or rebuild doesn't start...

[luis]

enabled the raid controller of my motherboard (silicon image 3112)
installed the driver and defined a raid 1 set.
Defined the source disk and the destination....
Then the Windows raid utility sent a message saying that the set was creating and that the rebuild was on going.... but nothing changed (% in the progress bar).

Decided to restart the PC and before XP starts accessed tge Raid utility: rebuild also didn't show progress
Deleted the set and recreated and asked for a copy (I have a disk with data....): no result

Any hint please?

When I say no result is because after 1 hour nothing moves and I don't hear any noise of disk access.....

TIA!
luis

 

[Guest]

Disconnect one of the RAID drives,start computer,boot to xp cd,press F6,
install drivers from floppy,after,at xp cd boot menu,press r for recovery,
disreguard the text,just typeiskPart In DiskPart,delete
partitions,create one,
press ESC key,type:EXIT Shutdown computer (power button).Unplug disk,plug
in other,do the same,after power off,plug in both,configure RAID set,boot to
xp cd,press F6,after proceed to install xp.Make sure BIOS is set for RAID.

 

[luis]

Hi Andrew,
thanks!
worked!

luis

Disconnect one of the RAID drives,start computer,boot to xp cd,press F6,
install drivers from floppy,after,at xp cd boot menu,press r for recovery,
disreguard the text,just typeiskPart In DiskPart,delete
partitions,create one,
press ESC key,type:EXIT Shutdown computer (power button).Unplug disk,plug
in other,do the same,after power off,plug in both,configure RAID set,boot
to
xp cd,press F6,after proceed to install xp.Make sure BIOS is set for RAID.