RAID Controller died... new controller will not boot hard drive...

[Guest]

The raid controller in this machine only supported 0 and 1. Installed new card that will support, 0, 1, 10, and 5. Connected the old drives to the new controller and boot the machine. The new controller sees the old drives as a RAID 1 setup. When Windows boots, it blue screens with no boot device. I am assuming this is because windows is expecting to see the old controller card... how can I force windows to see the new card, i.e., install the drivers for the new card into windows

Thanks.

 

[SaltPeter]

The raid controller in this machine only supported 0 and 1. Installed new

card that will support, 0, 1, 10, and 5. Connected the old drives to the
new controller and boot the machine. The new controller sees the old drives
as a RAID 1 setup. When Windows boots, it blue screens with no boot device.
I am assuming this is because windows is expecting to see the old controller
card... how can I force windows to see the new card, i.e., install the
drivers for the new card into windows?

Thanks.

Boot from W2K CD, F6 to specify mass storage controllers + choose repair.