Question about dual display and new cat 4.1

  • Thread starter Thread starter David Curtis
  • Start date Start date
D

David Curtis

G'day, After installing this new package I have this strange, new-to-me
behaviour in the way my displays are numbered. After I switched from
extended desktop mode to clone mode my desktop monitor is now display #2 and
my TV is display #1. See pic here -
http://home.cogeco.ca/~dcurtis/dualdisplayweirdness.jpg.

A couple of games now won't run because of the mix up. Anyone else seen this
happen?

Dave.
 
David said:
G'day, After installing this new package I have this strange, new-to-me
behaviour in the way my displays are numbered. After I switched from
extended desktop mode to clone mode my desktop monitor is now display #2
and my TV is display #1. See pic here -
http://home.cogeco.ca/~dcurtis/dualdisplayweirdness.jpg.

A couple of games now won't run because of the mix up. Anyone else seen
this happen?
Click to expand...


Just swap the primary and secondary display back.

If you go to the advanced video settings and the displays panel, the option
is there (think two blue boxes).

Ben
 
dcurtis_0123 said:
G'day, After installing this new package I have this strange, new-to-me
behaviour in the way my displays are numbered. After I switched from
extended desktop mode to clone mode my desktop monitor is now display #2 and
my TV is display #1. See pic here -
http://home.cogeco.ca/~dcurtis/dualdisplayweirdness.jpg.

A couple of games now won't run because of the mix up. Anyone else seen this
happen?

Dave.
Click to expand...

Same here, noticed the new drivers reloaded back to the default/plug
and play drivers. Reloaded the correct monitor definitions for the
displays then went into display properties and changed the
primary/secondary setting back to the way it should be. Now working
ok.

Bill
 
Back
Top