Procedure entry point couldn't be located....

  • Thread starter Thread starter Bob Fliegel
  • Start date Start date
B

Bob Fliegel

I have been using FP2000 for the last couple years. Today
I installed FP2003 Beta, but didn't replace the earlier
version. They are now two separate programs on my hard
drive. I cannot, however, access either of them,
receiving fol error msg: "procedure entry point couldn't
be located in the dynamic link library fpcutl.dll."
Obviously, my installation of 2003 created a path
problem. How can I fix it so that I can access either
version of FP? I did a search for that .dll file and
found that the earlier version is in
c:\ProgramFiles\MicrosoftOffice\Office and the later
version in c:\ProgramFiles\MicrosoftOffice\Office11.
 
I suppose I could simply uninstall both versions, then
reinstall only one of them. Would that serve to correct
the .dll path confusion?
 
Yes

And if you do reinstall the Beta (after you reinstall FP2000) make sure it is a custom install to a different folder than your
FP2000

--



| I suppose I could simply uninstall both versions, then
| reinstall only one of them. Would that serve to correct
| the .dll path confusion?
|
 
Bob Fliegel said:
I have been using FP2000 for the last couple years. Today
I installed FP2003 Beta, but didn't replace the earlier
version. They are now two separate programs on my hard
drive. I cannot, however, access either of them,
receiving fol error msg: "procedure entry point couldn't
be located in the dynamic link library fpcutl.dll."
Obviously, my installation of 2003 created a path
problem. How can I fix it so that I can access either
version of FP? I did a search for that .dll file and
found that the earlier version is in
c:\ProgramFiles\MicrosoftOffice\Office and the later
version in c:\ProgramFiles\MicrosoftOffice\Office11.
Click to expand...


i have the same prob. fp 2003 will not load...anybody from MS watching????
 
Explain what you have installed from the BETA CD's

--



| > I have been using FP2000 for the last couple years. Today
| > I installed FP2003 Beta, but didn't replace the earlier
| > version. They are now two separate programs on my hard
| > drive. I cannot, however, access either of them,
| > receiving fol error msg: "procedure entry point couldn't
| > be located in the dynamic link library fpcutl.dll."
| > Obviously, my installation of 2003 created a path
| > problem. How can I fix it so that I can access either
| > version of FP? I did a search for that .dll file and
| > found that the earlier version is in
| > c:\ProgramFiles\MicrosoftOffice\Office and the later
| > version in c:\ProgramFiles\MicrosoftOffice\Office11.
|
|
| i have the same prob. fp 2003 will not load...anybody from MS watching????
 
Back
Top